Januar 2, 2017 Wolfgang Schwarzmann

Edding-Klemme

yesterday i found some time to develope this small clamp. currently it doesn’t hold anything except it self but at least it works and fits properly. the metalparts are just a normal M5 screw and bolt with an additional 3d-printed key. if you tighten the hexagonal key its impossible to remove the screw from the edding. no use for it, but very impressed that it works…

you can see:

-The 3D-Modell in Rhino-3d (Software)

-The „.iges“ File in Slic3er

-The sliced (an ready to 3D-print) file (with support structure

-The new clamp and

-the use of the clamp

 

264_EddingKlemme

Tagged: , , , , , , , , , , , ,